Work Completed on Saturday, August 25, 2018
I started this work session by dimpling the W-00009B Wing Box J-Stiffener - Short and W-00009A Wing Box J-Stiffener - Long. Next, I started work on the Right Inboard Bottom Skin. The first step was to match-drill #40 the W-1010R Inboard Wing Rib at all nutplate rivet hole locations in the Bottom Inboard Wing Skin (in the areas with vertical row of rivets in the picture below). Then, the nutplate screw hole locations were final-drilled to #19.
Lastly, I deburred all the #19 and #40 holes.
—————————————————————————————————————————————
Work Completed on Sunday, August 26, 2018
I started tonight’s session by completing the edge work on the Left Inboard Wing Skin. Once completed that was completed, I moved on to the W-00005-L & -R Bottom Outboard Wing Skins. To complete the Outboard Skins, the following steps were completed:
1. Final-Drilled the #19 the screw holes in the Access Plate Attach locations
2. Deburred all the #40 and #19 holes
3. Cleaned all the edges
In the pictures below, I have clecoed the Inboard and Outboard Wing Skins in place on their respective wing (Right Wing in the first picture and the Left Wing in the second). The next step is to “sand” or trim forward areas where the two Skins overlap. This will be done in a similar fashion as when the Top Wing Skins were prepared (Parts 11 and 12).
Right Wing.....
Left Wing.....
