During today’s session, I ran the wiring for the WH-00012-ADAHRS in the Left Wing.
Pictured below is the wires and harness in the packaging from Van’s.
Here is the initial installation of the wires. The far left side of the wires are coiled (I used the orange tape) for later connection to whatever ADAHRS system I choose. (I plan on using Dynon Avionics).
So, that is all the wire runs for the Systems Routings (well, almost). I still have to run tubing for the pitot tube. However, I am waiting for the Dynon pitot tube to arrive. Once it does, I will install it and complete this section. I will be using a heated Dynon pitot tube with AOA.
So, I’ll “pause” Section 19 until I start the Pitot Tube install.