I spent today’s session deburring and cleaning the edges of several pieces of the Left Flap. These pieces included the FL-00003-L Spar, FL-00001-L Nose Skin, two FL-1004-L Nose Ribs, three FL-1005-L Main Ribs, and the Inboard and Outboard Rod End Rib Subassemblies.
I will debur and complete the the edge work for the remaining parts of the Left Flap during the next session.
_______________________________________________________________________________________________
Work Completed on Saturday, December 8, 2018
Previously, the #40 hole locations were measured and drilled in the joggled portion of the FL-1007-L Hinge Brackets. Today, the #40 hole locations for the matching FL-1007-R Hinge Brackets were match-drilled using the left as a guide.
The picture below shows the Inboard Subassembly. You can see the four holes in the Left Bracket (in between the clamps) that will be used as guides to match-drill the Right Bracket. I installed the the hardware in the hole where the Subassembly will be attached to W-1025A Flap Hinge Bracket (already installed on the Left Wing). This helped to hold the Subassembly together and tight (along with the clamps) for the match-drillling.
Opposite side of the same Inboard Bracket above.
The Outboard Subassembly prepared for match-drilling.
