After completing the Vertical Stabilizer (see previous post), I resumed work on the Rudder. In Part 3, I began the Alumiprep and Alodine process of a few of the parts and pieces that would fit into the bins. Today, I used spray bottles and a foam brush to prep a few of the bigger parts. I began by spraying the Alumiprep on the piece and scuffing it with grey Scotch Brite, rinsed with water, and sparayed on the Alodine. I used the foam brush to make sure all areas were covered on the pieces. Tomorrow, I will prime and begin assembling the Rudder skeleton.
This blog was created to memorialize the building process of my Van's Aircraft RV-14 and to satisfy the requirements for certification in the Experimental Amateur Built Aircraft category. It will also serve as a central location for ME to reference in the future on processes and techniques I used during the build. Additionally, it will allow my family, friends, and other interested builders the opportunity to follow along during my build…..and might be helpful to someone along the way.